![]() the 10"? Since it was advertised as an 11X36 and is obviously NOT 36" between centers, isn't it possible that it isn't an 11" swing either? I have the serial number. New Listing Rockwell Delta 33-990 Model 10 Radial Arm Saw Black Motor 438-0 W/Yoke Pre-Owned C 239.02 Top Rated Seller Buy It Now from United States Sponsored Vintage Delta Rockwell 34-500 8' Table Saw Arbor Bearings Set of 2 87503 Brand New C 34. So, either the thread table has been replaced by a Delta plate or if original, suggests that this lathe is newer than '84.Īnother concern is how do I know this is an 11" vs. Instead it reads D-E-L-T-AĪccording to Tony's site, Delta bought Rockwell lathes in 1984. Do not use the reference number off of the diagram. The thread table plate above the left gear selector did NOT read A-B-C-D-E as the Army Rockwell Manual indicates. Delta Circular/Table Saws Parts Lists Find the part number from the parts list and enter Part Number in the search box. I just remembered something I saw when I looked at the lathe and was wondering if there is any significance. Its a bit divergent from the original thread, so I thought I'd repost to a new one. I posted the following in the "11X36 Rockwell" thread, but that thread may have already run its course.
0 Comments
Leave a Reply. |